Toshiba B-SX8T SERIES Owner's Manual page 39

2. PRINTER SETUP
2.8.1 Parameter Setting
(Cont.)
NOTE:
The print head may not be raised
depending on the rise of the
solenoid's temperature.
When ON is selected, pressing the [PAUSE] key will result that the LCD
Message Display shows the stop position fine adjustment value setting
screen.
<2>PARAMETER SET
POSITION +0.0mm
[RESTART]
[FEED]
[FEED] key: Pressing the [FEED] key one time causes a –0.1mm change,
up to –5.0 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a +0.1mm
change, up to +5.0 mm.
After selecting an auto forward wait, press the [PAUSE] key.
(10) Head Up Cut Selection
This parameter is to choose whether to activate the head up action in the
cut issue.
This function prevents ribbon smudges by raising the print head during a
reverse feed to the print start position.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
HEAD UP CUT OFF
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the head up action in cut issue, press the [PAUSE] key.
E2-25
ENGLISH VERSION EO1-33057
2.8 Setting an Operating Environment
POSITION +5.0mm
POSITION +0.0mm
POSITION -5.0mm
HEAD UP CUT ON
HEAD UP CUT OFF
Activated
Not activated