Cleaning The Swim Spa Interior; Pillow Care - Jacuzzi SWIMSPA Series Owner's Manual

9. To completely flush the old water from the plumbing lines: allow fresh water to fill
into the foot-well area while the old water continues to be pumped out. Always
keep at least 10cm (4 in.) of water in the foot-well so that pump 1 remains primed.
10. When the water from the drain hose turns clear (indicating fresh fill water), flush is
complete.
11. Turn OFF the filtration pump.
12. Close the drain-hose bib on the swim spa plumbing line and
continue filling swim spa with fresh water.
13. Place cover on swim spa (to avoid splash-out).
14. Open filtration pump return gate valve.
15. Press any button on the topside control panel (other than the pump 1 button) to
take the system out of STANDBY/DRAIN ASSIST mode. Filtration pump and the
heater will activate to circulate and heat the water while filling continues. This also
reduces the possibility of an airlock occurring.
16. Continue adding fresh fill water until level is approximately 19mm (3/4 in.) from the
top of the skimmer opening.

12.3 Cleaning the Swim Spa Interior

To preserve the sheen of your swim spa's surface, it is crucial that you avoid using abrasive
cleaners or cleaners which have adverse chemical effect on the surface. If you are not cer-
tain as to the suitability of a particular cleanser, consult your authorized Jacuzzi dealer. We
recommend using Jacuzzi's Spa All Purpose Cleaner to clean the swim spa's interior surface.
Use extreme care to assure that no soap residue is left on the surface. This could cause se-
vere sudsing when the swim spa is refilled. Jacuzzi chemicals are for use in the U.S. only.

12.4 Pillow Care

Clean the headrests in your swim spa as needed by wiping them with a cloth with soapy
water. It is not necessary to remove the headrests for cleaning. To remove headrests for
long term storage or replacement, grasp both ends of each headrest and gently pull inward
towards the center of the swim spa. To reinstall, over mounting strip and press down until
headrest mounting bracket emits a "click" sound. Then adjust the headrest height by simply
moving up or down as desired.
41