Pillow Care; Cleaning The Spa Interior - Jacuzzi J-135 Owner's Manual

CAUTION! READ THIS BEFORE DRAINING: To prevent damage
to the spa's components, turn off power to the spa at the circuit
breaker before draining it. Do not turn the power back on until
your spa has been refilled.
CAUTION: There are certain precautions to keep in mind when drain-
ing your spa. If it is extremely cold, and the spa is outdoors, freezing
could occur in the lines or the equipment, see "WINTERIZING" (page
39). On the other hand, if it is hot outdoors, do not leave the spa's
surface exposed to direct sunlight.
To drain your spa, perform the following steps (actual
drain may vary from one shown). Turn off power to
spa at breaker.
1. Locate and remove the synthetic cabinet screws.
The cabinet is located directly below the control
panel.
2. Cut zip tie(s) and pull drain hose from equipment
area (Figure A).
3. Hold drain hose above water line, then unthread
drain cap (1) from hose using a counterclockwise
rotation (Figure B). Place drain hose on ground to
start drain, making sure to direct water away from
spa. If equipped, turn valve (2) counterclockwise
to open the valve (Figure C).
4. After spa is drained, reinstall drain cap on drain
hose fitting until finger tight! If equipped, turn
valve (2) clockwise to close the valve. DO NOT
OVERTIGHTEN!
5. Coil drain hose up and place back inside the spa
equipment bay (Fig. A).
6. Reinstall synthetic cabinet and screws, then refer
to the "Spa Fill Up Procedure" (page 19).
12.3

Pillow Care

Remove and clean each headrest by gently grasping both ends in each
hand and pulling upward to release each pillow "snap." To reinstall, simply
"snap" each pillow back into place. Clean as needed with soapy water
using a cloth or soft-bristle brush. Always remove the pillows when adding
chemical shock treatment to the spa water. The pillows can be returned to
the spa when the sanitizer reading is stable as recommended on the inside
cover of the manual.
12.4

Cleaning The Spa Interior

To preserve the sheen of your spa's surface, it is crucial that you avoid
using abrasive cleaners or cleaners which have adverse chemical effect
on the surface. If you are not certain as to the suitability of a particular
cleanser, consult your authorized Jacuzzi dealer. Regardless of the
cleanser used, use extreme care to assure that no soap residue is left on
the surface. This could cause severe sudsing when the spa is refilled.
J-100
Figure A
2
1
Figure B
Figure C
Drain location
and appearance
may vary.
37