Jacuzzi SWIMSPA Series Owner's Manual page 50

PROBLEM
POOR JET ACTION
WATER IS TOO HOT
NO HEAT
FILTER / CIRCULATION
PUMP OFF
Jacuzzi builds the best swim spas in the industry. Nonetheless, we are always striving to
improve the quality and features of our products. Your input as a Jacuzzi swim spa owner
is a cherished part of this process. If you have any comments or suggestions, or wish to be
informed on any new products for your swim spa, please write to us.
CONGRATULATIONS on your good taste and welcome to the happiest and most relaxed
family in the world!
PROCEDURE
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system
4. Check for adequate water level.
5. Check for dirty filter.
1. Reduce thermostat setting.
2. Switch swim spa to "Econo" mode to turn heater on only during
pre-programmed time.
3. Make sure the pumps are turned off an not constantly running.
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If the heater indicator is displayed, but no temperature increase
is experienced after a reasonable period of time, contact your
dealer or authorized service organization.
1. Verify filter / circulation pump is programmed to run 8 hours a
day.
2. Make sure there are no errors preventing the pump from turn-
ing on.
3. Swim spa water is warmer than 95
warmer than the set temperature.
o
F (34
50
o
C) and two degrees