Reference
Designation
Manual condensate drain
6
Hole, 15 x 25 (3X)
7
Receiver
8
Cooling air inlet
9
Motor cooling air inlet
10
Compressed air outlet
11
Compressor cooling air and air inlet
12
For dismantling air filter
13
Compressor air outlet with flexible (2 meters)
14
Electric cable entry (on rear side)
15
Air outlet
16
Manual condensate drain
19
3.2
Installation instruction
Install the unit in an area where the noise levels do not cause inconvenience and adequate
ventilation is available for cooling purposes.
Before commencing installation, check that the electrical data on the compressor
specification plate/s are compatible with the local power supply. Before connecting, the
electricity, ensure that the power supply is off and correctly isolated.
The electrical power supplied to the compressor unit must be connected by a qualified
electrician in accordance with the wiring diagram supplied with the plant. All wiring must be in
accordance with IEE regulations. Cable sizes given in section. Electric data are
recommendations only.
36
Installation proposal for tank-mounted unit (90 l receiver)
Instruction book
2920 7090 00