Table of Contents
Advertisement
PLANAR
Getting
Started
When you install your ELT320 all operating features are set to their factory-default
settings. This setting works with most computer systems. If you have to set some
features to match your host system, see Chapter 4 -Set-up.
To connect the terminal to your host system you must have the following properly
set:
.The host port selected for use-
.The
keyboard language.
.The baud rate and character fonnat.
.The emulation type.
Brightness Control
The brightness control is a thumbwheellocated at the bottom edge of the face of
the terminal. The control adjusts the display's brightness level from full bright to
half bright This range allows the user to change the brightness to compensate for
environmental light levels. Clockwise rotation increases the display brightness.
When the brightness is reduced, contrast is diminished.
Note: Some units do not have brightness controls.
Power On Indicator
When the EL T320 Power Switch has been pressed to the On position, a yellow
LED indicates the 12V power supply is on.
-~r:=:::-
/
Brightness
Control
(thumbwheel)
Power "on" indicator
~
""
EL T 320 Flat Pannel
Monitor
~~~~~
mounted
on the Desk
Stand
Figure 2-3
The ELT320 and the Brightness control
Advertisement
Table of Contents
