Table of Contents
Advertisement
EL 1320
Installation
and Users Guide
CAUTION: Turn the power switch off before connecting or removing the cables.
Installation of the EL 1320 terminal
Place the terminal unit at the work station.
?
Check to see if the terminal is switched off (press the BO1TOM of the
power switch, found on the rear of the tenninal.)
Connect the power module to the terminal power connector.
3.
4.
Next connect the power cord to its receptacle on the end of the power
module and plug it into a grounded electrical outlet.
Connect the keyboard cable to its receptacle on the back of the terminal
unit.
5.
Connect the host computer communication cable to the appropriate HOST
port. Check the proper connector pin assignment See Chapter 7 the
Technical Specifications for host connector details.
6.
7
Connect a printer communication cable, if required, to the PRImER port.
Note: This cable is not supplied with the ELT320 terminal.
8.
9.
10.
Turn the terminal power switch on (press the top of the power switch.)
Make sure that the yellow power indicator is on.
Listen for a bell tone from the keyboard.
After the power-on self test, the "ELT320 OK" message appears on the
screen. Press F3 to see the Set-Up Menu or any other key to clear the
screen and obtain a cursor.
11.
If you have problems, see "Problem Solving" at the end of this chapter.
12.
Connection to Host Computer
t
The EL T320 can be connected to the host computer through the HOST connector.
The HOST 9 pin D type connector is an RS-232-C interface.
The HOST 6 pin DEC type connector is an RS-423 interface.
The RS-232-C connection can be made directly to the host or through a MODEM or
terminal selVer to host.
Communication
parameters
can be selected in Set-Up. (See Chapter 4 in this
Manual.)
Advertisement
Table of Contents
