Table of Contents
Advertisement
Loewe klang 9
User handbook
Connecting Loewe klang 9 via LINE IN
Connecting Loewe klang 9 via LINE IN
Via the LINE IN analogue interface, you can connect the klang 9 to your TV set or any audio source.
Disconnect all devices from the mains before connecting.
Connect the analogue audio output AUDIO OUT
the supplied 3.5 mm jack/2 x cinch audio cable. If an audio source is used, which has separate jacks for left/right; use appropriate standard cinch cables.
Connect the cables to the speaker according to the corresponding installation instructions.
Use the mains cable supplied to connect the 220-240 VAC 50/60 Hz socket of the klang 9 to a 220-240V 50/60 Hz socket.
If the menu item TV speaker is active in the sound components wizard of the Loewe TV set, it may happen that after turning on the TV set, the klang 9 connected
to AUDIO OUT is operated at a high volume. Therefore, select in the sound components wizard first the Speaker system (AUDIO OUT)
speaker to the mains.
Mains socket
Mains cable
Loewe klang 9 (right)
(1
For Loewe TV sets as of chassis SL3xx and software V2.2.13 without AUDIO OUT connector, use the HEADPHONE connector.
(1
of the TV set or of another audio source with the LINE IN audio inputs LEFT/RIGHT of the speaker. To do so, use
Audio cable 3.5mm jack / 2x cinch
another audio source/
TV-set (AUDIO OUT)
(1
before connecting the
Mains socket
Loewe klang 9 (left)
Mains cable
11
Advertisement
Table of Contents
