Advertisement
Installation Instructions
1. Check box contents.
2. After marking door inside face for device location (Device
Instructions), transfer "Vertical Reference Centerline" from inside to
outside door face. Follow steps 2a and 2b, at right.
3. Transfer "Horizontal Reference Centerline" from inside to outside door
face.
4. Orient and align trim template, attach with tape to outside door face.
5. Spot holes and prepare door for trim.
6. Adjust trim for door thickness (as reqd).
7. Mount trim to door thru holes "B" with (2) #10-32 x 2" PTHMS
supplied as shown in Fig. 1.
Note: If installing dummy trim, continue as shown in device
instructions.
8. If required, cut trim tailpiece as shown in Fig. 2. Seat device so that
the trim tailpiece penetrates cam slot as shown in Fig. 1. Thru mount
device to trim thru holes "A" as shown in Fig. 1 using 1/4-20 PPHMS
supplied with device.
9. Continue as shown in device instructions.
INSTALLATION INSTRUCTIONS - RHR Shown*
* - Trim Assembly shipped non-handed, rotate assembly
180° for use with LHR application.
540F Series Trim
(2) #10-32 x 2"
Machine Screws
580F Series Trim
Escutcheon Plate Assembly
An ASSA ABLOY Group brand
Tailpiece
For thick door applications use
60-1500-1819. (Ordered Separately)
Secure with pin.
Truss Head
(2) #8-32 Flat Head
Machine Screws
Packed with device.
(2) 1/4-20 Pan Head
Machine Screws
Figure 1
Device is bolted
to trim using
holes "A" (closest
to door lock edge)
(2) Screws and
washers bolt trim
to door using
holes "B"
Figure 2:
Tailpiece Sizing
Device
Mounting
Surface
(See Note)
Trim
Tailpiece
Hold 5/16
(8)
Cut Line
NOTE:
Measure from device mounting
surface (door face or shim surface)
80-8470-0541-000 (11-12)
Tailpiece (T)
engages with
cross hole of
cam slot.
Cut per Fig. 2
LHR Door
Shown
Trim
Mounting
Surface
2
Advertisement
