Rev-A-Shelf 548 Series Installation Instructions

Installation Instructions for:
548 Series
Pull-Out Wire Baskets
Tools required: #2 Phillips Screwdriver, Level, and Pencil
Step 1 - Frame or Frameless
Cabinet Installation
Position basket in cabinet
against left or right side wall
flush with front cabinet
opening and mark upper and
lower slide screw locations
on cabinet wall with a pencil.
Make sure to allow enough
clearance beneath basket to
allow for smooth travel when
sliding unit out of cabinet.
(Illustration 1)
Step 3 - Attaching basket
to slides
Attach basket to slides
using the four (4) provided
4mm pan head screws.
Attach screw through
basket and into slide.
(Illustration 3)
Your installation is now
complete.
NOTE: For Door-Mount Installation
Follow above steps 1 thru 3. Use four (4) additional
wood screws (Not Supplied) to attach door front to wire
basket (Not recommended for doors larger than 9"
wide). If door mounting in frameless cabinet without
hinges installed, eliminate spacers and attach slides
directly to cabinet wall with the four (4) provided #8 x
5/8" flat head screws.
I-548
Illustration 1
Illustration 3
#8 x 1 1 Flat
⁄ 4 "
Head Screw
Step 2 - Attaching spacers
and slides to
cabinet
Attached slides to cabinet
wall using four (4) provided
#8 x 1 1 " flat head screws.
⁄
4
(Illustration 2)
Place screw through slide
and spacer assembly then
screw into cabinet wall.
548-06
4mm Pan
Head Screw
Illustration 2