Table of Contents
Advertisement
5. Manual Defrost
Press and hold the defrost
on.
6. Parameter Programming
1) Press and hold the SET +
then release the keys.
2) Press and hold again the SET +
release the keys. The first parameter Hy will be displayed.
3) Press up/down keys
4) Press the "SET" key to display its value.
5) Use up/down keys
6) Press "SET" to store the new value and the display will flash 3 times.
7) To exit: Press SET +
PARAMETER
Set
Hy
temperature regulation differential
AC
Con
compress on with probe faulty (min)
CoF
compress off with probe faulty (min)
CF
rES
dLy
temperature display delay (min)
ot
LS
US
idF
MdF
ALC
ALU
ALL
AFH
alarm recovery differential
ALd
temperature alarm delay (min)
dAO
temperature alarm delay on startup (hr)
SAA
SHy
heater regulation differential
FSU
FnC
Fon
fan on with compressor off (min)
FoF
fan off with compressor off (min)
NOTE
Depending on the controller, not all parameters are available
key until defrost starts. The defrost indicator will be
keys until the "°C" or "°F" LED starts flashing,
/
to scroll to the required parameter within 10 sec.
to change its value within 10 sec.
or wait 15sec without pressing a key.
DESCRIPTION
°
set-point (
)
anti-short cycle delay (min)
°F/ °C
temperature unit
(
display resolution
°
probe calibration
(
)
°
minimum set-point
(
°
maximum set-point
(
defrost interval time (hour)
defrost endurance time (min)
temperature alarm type
high temperature alarm
low temperature alarm
°
heater set-point
(
)
fan action
fan operating mode
keys until the Pr2 label is displayed, then
°
(
)
)
)
)
rE: relative to set-point
°
(
)
°
(
)
°
(
)
°
(
)
C-n: on with compressor & off during defrost
- 8 -
DEFAULT VALUE
55
4
10 (hidden)
15
30
F: Fahrenheit
in: integer
1
0
50
65
12
30
10
10
5
60
23
40
4
Std
0
15
Advertisement
Table of Contents
