Milwaukee M12 FUEL ONEFTR12 Operator's Manual page 7

Accuracy Certification
This tool will require certification: after annual
calibration, or 5,000 cycles, or if the tool has been
overloaded. NOTE: Once tool has exceeded
5,000 cycles, the tool will be out of certification
and will expire after 14 days. Contact your local
Milwaukee Tool service centre if the tool is
overloaded. Refer to the troubleshooting section
within the manual for more information.
Calibration
This tool was calibrated at the factory with
torque measurement
MILWAUKEE® service
Torque parameters comply with ISO 6789-2003
and ASME B107-28-2010.
ACCESSORIES
Use only recommended accesso-
WARNING
ries. Others may be hazardous.
For a complete listing of accessories, go online to
milwaukeetool.com.au/ milwaukeetool.con.nz or
contact a distributor.
instruments. Contact
facility for calibration.
a
7