Radio Mode - Silvercrest SBLL 4.2 A1 Operating Instructions And Safety Instructions

* An acoustic signal is played when the maximum
volume is reached.
1
You will hear a confirmation tone in the speaker.
Subsequently the Bluetooth
established.

Radio mode

The speaker has a radio function. Proceed as follows to
use the speaker in radio mode.
 Connect the supplied USB charging cable (B) to the
micro-USB charging port (9) on the speaker. The USB
charging cable (B) is used as the antenna in radio
mode.
 Turn the speaker on by setting the ON/OFF switch
(6) to the 'ON' position. You will hear a series of
sounds that gradually increase in volume. 'bLUE' is
shown on the display (1).
 Briefly press the M button (3) to switch to radio
mode. The most recently used radio frequency is
shown on the display (1).
 To start automatic station scanning, briefly press the
button (2). Automatic station scanning always
begins with the lowest frequency.
 The speaker now scans the entire frequency range for
stations with a strong signal. As soon as a station with
a strong signal is found, the frequency indicator
briefly freezes on the display (1) and the memory
position where this station will be stored is displayed
for a short time.
SilverCrest SBLL 4.2 A1
®
connection has to be re-
English - 15