Bluetooth Mode - Silvercrest SBLL 4.2 A1 Operating Instructions And Safety Instructions

 Disconnect the USB charging cable (B) from the
speaker after charging.
If a battery has almost run out, this will be
indicated by a series of sounds.
WARNING! The device is not covered
while charging, as the device can heat up
in the process
Bluetooth
The Bluetooth
®
Bluetooth -equipped music player such as your
smartphone or MP3 player with the speaker. Once the
two devices are paired, you can play music over the
speaker and operate the main controls of the player
remotely using the buttons on the speaker.
Proceed as follows to pair the speaker with your mobile
phone or player:
 Turn the speaker on by setting the ON/OFF switch
(6) to the 'ON' position. You will hear a series of
sounds that gradually increase in volume. The display
(1) shows 'bLUE' and the LED (7) quickly flashes
blue.
 Now connect your mobile phone or player to the
speaker via Bluetooth
mobile phone manual. From the list of devices
detected, select device 'SBLL 4.2 A1' and establish
the connection. Enter '000' if you are asked for a
PIN.
 The speaker confirms the establishment of the
connection with a series of sounds that gradually
increase in volume, and the LED (7) lights up blue.
During transmission the LED (7) slowly flashes blue.
®
mode
®
connection allows you to pair a
®
. To do so, refer to your
SilverCrest SBLL 4.2 A1
English - 13