Assembly Instructions - Troy-Bilt TB190BV Operator's Manual

BLOWER ASSEMBLY
WARNING:
To avoid serious personal injury, be sure
the unit is off and unplugged before assembling any
components.
1. With the unit off and unplugged from the wall, install the blower tube
onto the motor housing. Turn the tube clockwise until it locks (Fig. 1).
Motor Housing
2. Insert the blower concentrator tube onto the blower tube and
turn it clockwise to lock (Fig. 2).
Concentrator Tube
NOTE: The blower tube and concentrator tube must be used at all
times when in blower mode to prevent the motor from
overheating.
VACUUM ASSEMBLY
WARNING:
To avoid serious personal injury, be sure
the unit is off and unplugged before assembling any
components.
WARNING:
The upper and lower vacuum tubes must
be used attached together at all times. To avoid serious
personal injury, the unit can not be operated with only one
vacuum tube.
1. With the unit off and unplugged, release the vacuum door by
carefully inserting a flat head screwdriver into the latch opening
(Fig. 3). Twist the tip of the screwdriver gently and pull open
the door with your other hand (Figs. 3 and 4).
All manuals and user guides at all-guides.com

ASSEMBLY INSTRUCTIONS

Blower Tube
Fig. 1
Blower Tube
Fig. 2
Fig. 3
2. Align the arrow on the upper vacuum tube with the arrow on
the motor housing (Fig. 5). Note that the flat on the upper
vacuum tube faces the vacuum door as you install the tube.
Motor
Housing
Vacuum
Flat
Door
3. Slide the upper vacuum tube into the motor housing. Turn the
tube clockwise until the dot on the tube aligns with the dot on
the motor housing (Fig. 6).
Upper
Vacuum Tube
4. Slide the lower vacuum tube into the upper vacuum tube. The
arrow on the lower vacuum tube should align with the arrow
on the upper vacuum tube (Fig. 7).
Upper Vacuum Tube
5. Turn the tube clockwise until the dot on the lower vacuum tube
aligns with the dot on the upper vacuum tube (Fig. 7).
NOTE: For electric vacuum kits, the shorter end of the vacuum
bag elbow tube with the raised ribs should be inserted
through the zipper opening (Fig. 8).
Fig. 4
Upper Vacuum Tube
Fig. 5
Motor
Housing
Fig. 6
Lower Vacuum Tube
Fig. 7
5