Blower Assembly; Vacuum Assembly; Assembly Instructions - Troy-Bilt TB120BV Operator's Manual

ASSEMBLY INSTRUCTIONS

BLOWER ASSEMBLY

To avoid serious
WARNING:
personal injury, be
sure the unit is off
and unplugged before assembling any
components.
1. With the unit off and unplugged, press down the
button (A) and install the regular nozzle (B) onto
the motor housing (C). (Figs. 1 and 2)
2. Insert the concentrator nozzle onto the regular
nozzle to lock (Fig. 2 ). (Concentator nozzle is
used to increase air flow in tight areas : flower
beds, under decks, etc.).
C
A
B
Fig. 1
D
To remove : lift locking
tab (D).
REAR HAND
GRIP
REGULAR NOZZLE
CONCENTRATOR NOZZLE
Fig. 2

VACUUM ASSEMBLY

To avoid serious
WARNING:
personal injury, be
sure the unit is off
and unplugged before assembling any
components.
To avoid serious
WARNING:
personal injury, the
vacuum tube
assembly must be used whenever the vac-
uum door is open to avoid contact with
rotating blades.
1. With the unit off and unplugged, remove regular
nozzle from motor housing by pressing down but-
ton (A) and pulling regular nozzle off (Fig. 1).
Then release the vacuum door by carefully insert-
ing a flat head screwdriver into the latch opening
(Fig. 3). Twist the tip of the screwdriver gently and
pull open the door with your other hand (Fig. 3
and 4).
Fig. 3
Fig. 4
6
ASSEMBLY INSTRUCTIONS
2. Take off the Air collector (B)(Fig. 5).
3. Align the arrow on the upper vacuum tube with
the arrow on the motor housing (Fig. 6).
4. Insert the upper vacuum tube into the motor
housing. Turn the tube clockwise until the dot on
the tube aligns with the dot on the motor housing
(Fig. 6).
B
Fig. 5
MOTOR
HOUSING
UPPER
VACUUM TUBE
Fig. 6
5. Align grooves (D) on the lower vacuum tube with
locking hole (C) in the upper vacuum tube (Fig. 7)
then connect 2 tubes until the 2 arrows line
up.(Fig. 8)
C
D
UPPER VACUUM
LOWER VACUUM
TUBE TUBE
Fig. 7
Fig. 8
6. Attach the vacuum bag to the vacuum bag
adapter. (Fig. 9)
7. Press down the button (E) and insert the bag
adapter into the unit.(Fig. 10, 11 and 12)
Fig. 9
E
Fig. 10
Vacuum bag
WARNING:
assembly must be
used at all times
during vacuum mode to prevent personal
injury from objects being discharged from
blower outlet and to prevent overheating of
motor.
7