Maintenance - Black & Decker Firestorm FS1300CSL Instruction Manual

642742-00 01 FS1300 FS1500CSL
• Let the blade run freely for a few
seconds before starting the cut.
• Apply only a gentle pressure to the
tool while performing the cut.
• Work with the shoe pressed against
the workpiece.
HINTS FOR OPTIMUM USE
• As some splintering along the line of
cut on the top side of the workpiece
cannot be avoided, cut on the side
where splintering is acceptable.
• Where splintering is to be minimized,
e.g. when cutting laminates, clamp a
piece of plywood onto the top of the
workpiece.
POCKET CUTTING (FIG.17)
POCKET CUTTING IS USED TO CUT A
HOLE IN A PIECE OF MATERIAL
WITHOUT CUTTING FROM THE SIDE.
• Measure and mark work.
• Tilt saw forward and rest front of the
shoe on material to be cut. Align so
that cut will begin at the back of the
drawn rectangle shown in figure 17.
17
• Using the retracting lever, retract
blade guard to an upward position,
with the blade just clearing the
material, start motor and gradually
lower the saw into the material.
WARNING: As blade starts cutting
the material, release the retracting lever
immediately.
• Never tie the blade guard in a raised
position.
• When the shoe rests flat on the
material being cut, complete the cut in
forward direction.
• Allow the blade to come to a complete
stop before lifting saw from material.
• When starting each new cut, repeat
the above steps.
WRENCH STORAGE (FIG.18)
The blade wrench (10) can be stored on
the saw shoe as shown in figure 18.
11/29/07 2:18 PM Page 11
18

MAINTENANCE

Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part
of the tool into a liquid.
IMPORTANT: To assure product
SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other
than those listed in this manual) should
be performed by authorized service
centers or other qualified service
organizations, always using identical
replacement parts.
LUBRICATION
Black & Decker tools are properly
lubricated at the factory and are ready
for use.
ACCESSORIES
Recommended accessories for use with
your tool are available from your local
retailer.
WARNING:The use of any accessory
not recommended for use with this tool
could be hazardous. Use only 7-1/4 in.
(185mm) blades with 5/8 in. diameter
arbor. Exception: 7 in. (175 mm)
abrasive blades can be used.
When cutting metal, be careful of hot
sparks which are thrown by the blade.
SERVICE INFORMATION
All Black & Decker Service Centers are
staffed with trained personnel to provide
customers with efficient and reliable
power tool service. Whether you need
technical advice, repair, or genuine
factory replacement parts, contact the
Black & Decker location nearest you. To
find your local service location, refer to
the yellow page directory under "Tools—
Electric" or call: 1-800-544-6986 or visit
www.blackanddecker.com
FULL TWO-YEAR HOME USE
WARRANTY
Black & Decker (U.S.) Inc. warrants this
product for two years against any
defects in material or workmanship. The
defective product will be replaced or
repaired at no charge in either of two
ways.
The first, which will result in exchanges
only, is to return the product to the
retailer from whom it was purchased
11
10