90L
+60%
0%
-60%
ASSEMBLY AND SET-UP
Turntable Assembly
(1)Place the platter on the center spindle. The platter will
adjust itself to best fit over the spindle.
(2)Adjust the positioning of a platter so that a screw goes
into a screw holes.
(3)Tighten screws using a driver and fix a platter and a
main unit.
(4)Place the slip mat on the platter.
NOTE
In case of an assembly, be careful so that a main unit
and a platter do not collide strongly.
If the player is operated without fixing the screws, the
platter may not rotate properly.
Do not plug into a power outlet until this unit is fully
assembled and adjusted.
Installing the Balance Weight
From the backend of the tone arm (towards the rear panel)
place the balance weight onto the shaft and turn counter
clockwise. (Refer to the illustration)
All manuals and user guides at all-guides.com
180
-60%
0%
-60%
-60%
0%
-9-
+60%
0%
90R
-60%
0%
-60%
+60%
0%
DRIVER