EXCHANGE THE FADER UNIT
①Remove the 4 screws which fix the fader unit, and
remove the fader unit from position in this unit.
②Raise fader unit and remove both the surface fader
panel and the buffer rubber below the panel.
③Carefully remove the multi-cable connector from the
fader unit.
④Remove the fader knobs.
⑤Remove the bracket which is screwed to fader volume
from the removed fader unit. (see the right picture)
⑥Fix the bracket to the new fader unit in the way of
reverse process.
⑦Attach multi-cable connector to new fader unit.
⑧Position the fader unit carefully and secure with screws.
NOTE
The buffer rubber is very important part to avoid the
stylus skip. Be careful not to lose it when you change
fader unit. When you change to new fader unit,
please fix the buffer rubber properly.
【Instructions for cross fader CF-CPV replacement】
①Unscrew the two screws on the
CF-PCV panel and volume as it is
shown below
All manuals and user guides at all-guides.com
②Set the change switch of the CF-
PCV to PMC
PMC Connecter
-14 -
③Connect the QFO bracket to the
CF-PCV fader volume
NOTE
CF-PCV has to types of connectors
but connect it to the PMC connector
as shown below
Set this switch to "PMC"
FADER KNOB
FADER PANEL
BUFFER RUBER①
BRACKET
FADER VOLUME
CONNECTOR CABLE
BUFFER RUBER②
BRACKET
FADER VOLUME