worn out. Please see the "EXCHANGE THE FADER
UNIT" section of this manual.
uMASTER LEVELVOLUME
Adjusts the signal level outputs from MASTER OUT.
iMASTER MUTE SWITCH
This is the switch which mutes the output sound signal
from MASTER OUT jack of the rear panel. If you turn
the switch on, the output will be muted.
SIDE
!0 P OWER SWITCH
Use to turn power on.
NOTE
This switch should be turned on after you have turned
off all input devices and before
you turn on any devices attached to output.
!1 C .F. CURVE SWITCH
Select the cross fader curve. When this switch is slide to
right side it gives a steep cross fader good for
scratching and cutting. When sliding to the left side it
gives a gentle cross fader good for long running mixes.
BOTTOM
!5 I .F. REVERSE SWITCH
Reverses the action of the input fader by marking the
zero point top instead of bottom.
REAR PANEL
REAR PANEL
!7 M ASTER OUT JACK
Connect to the line/AUX input of power amplifier/mixer.
!8 L INE INPUT JACK
Connect the equipment with line level output (-10dB or
0dB), such as CD players, tape decks, DATs, MDs, etc.
The signal from line level equipment is fed to the PGM
channels when Line input is selected.
!9 A C POWER CODE
Connect the AC power cord to suitable outlet.
All manuals and user guides at all-guides.com
oMONITOR SELECT SWITCH
This switch is used to select the way of monitoring from
PGM1・・・・・ It allows you to hear input signal of PGM1.
MASTER ・・ It allows you to hear the signal of MASTER
OUT.
PGM2・・・・・ It allows you to hear input signal of PGM2.
!2 P HONES LEVEL VOLUME
Adjusts the headphone monitor level.
!3 P HONES2 JACK -MINI JACK(φ3.5)
Connect the headphones with a 1/8" mini headphone plug.
!4 P HONES1 JACK -PHONE JACK(φ6.3)
Connect the headphones with a standard 1/4" stereo
!6 C .F. REVERSE SWITCH
Reverses the action of the cross fader by switching
MODEL NO. QFO
L
100V 50/60Hz 15W
R
MADE IN CHINA
SERIAL NO.
LINE
2
MASTER
LINE
1
OUT
18
17
18
-7-
following.
(the impedance of 8ohm to 600ohm)
plug. (the impedance of 8ohm to 600ohm)
PGM1 and 2.
19
NOTE
This unit has been manufactured to fit strict quality and
safety standards. PLEASE ENSURE that you use the
correct power supply as shown on the rear panel of
this device. FAILURE to do so many result in shock
and/or serious damage to this unit and/or users.