ADJUSTMENT
NOTE
Be careful not to touch your finger to the stylus tip
during the adjustment.
Adjustment of Horizontal Zero(0) Balance
①Install the cartridge, headshell and balance weight to the
tonearm.
②Adjust the dynamic stylus pressure knob ob the tonearm
to Zero.
③Carefully release the tone arm from the tone arm clamp.
④Turn the balance weight clockwise or counterclockwise
until balanced horizontally.
NOTE
In case the balanceweight is moved, do the adjustment
of horizontal zero balance again.
⑤Return the tonearm to the armrest.
⑥Loosen the dynamic Stylus pressure adjustment knob
and pull it to the position with appropriate needle
pressure, tighten the knob.
NOTE
Exceeding stylus pressure recommendations may
couse skipping and/ or reduce stylus life.
Loosen
Loosen
Adjustment of Tone-arm Height
In case of the height of Tone-arm is needed for
adjustment, it is possible to adjust the height by loosening
the Tone-arm Height Fixed Screw. The adjustment range
is 9mm at the maximum. In case of 16mm cartridge height
→ Adjustment of tone-arm height do not need. In case of
25mm cartridge height → Adjustment of tone-arm height
need to set 9mm(MAX).
NOTE
Be sure to tighten the Tonearm Height Screw well. The
stylus may jump/skip if the height setting is not secured.
All manuals and user guides at all-guides.com
-12-
a)When the balance weight and cartridge are
balanced, the tone arm is held horizontal.
b)Excessive forward advancement of the balance
weight causes the cartridge side to be lowered.
c)Excessive backward retreatment of the balance
weight causes the cartridge side to be raised.
Slide and adjust
Slide and adjust
Loose
Loose
Dynamic Stylus Pressure
Dynamic Stylus Pressure
Adjustment knob
Adjustment knob
Tighten
Tighten
Screw Driver
Tighten
tTghten
COIN
Arm Height
Adjustment Screw