Advertisement
All manuals and user guides at all-guides.com
9. Installation (AMD Sempron / AMD64 - 754/939/940)
1) Fasten Nipples
Place a big washer on the motherboard. Then, put a nipple over it and fasten the nipple until the
motherboard is firmly stuck to the backplate.
* Retention Guide is not needed when installing CNPS7000B on Socket 754/939/940.
Big Washer
2) Apply Thermal Grease
Clean off particles and residue and then spread the
included thermal grease thinly and evenly over the
CPU that touches the FHS surface.
3) Insert Bolts
Insert the two bolts into the outer holes of the clip.
4) Place FHS
Set the FHS at the center of the CPU. Screw the
bolts in slightly, and then tighten them in an alternating
fashion until the nipples are completely pressed against
the clip.
5) Supply Power (Connect FAN MATE 2)
◆
Please refer to FAN MATE 2 Installation and Usage on page 7.
The specifications of any product may change without prior notice to improve performance.
※
Motherboard
Backplate
Nipple
CPU (Lid)
Thermal Grease
Bolt
Outer Hole
Clip
FHS
Nipple
6
Advertisement
