Advertisement
3) AMD Sempron / AMD64 - Socket 754/939/940
All CPUs conforming to Socket 754/939/940 platform
Cautions )
① No components higher than 39mm (possible examples: PSU,
graphics card, RAM, etc.) should be present within a 55mm
radius from the center of the CPU to install this product.
② For more information, please visit the Zalman website
(http://www.zalman.co.kr) and refer to "CNPS7000(A/B) "Compatible
Socket 754/939/940 Motherboards List" link.
7. Installation (Intel Pentium 4 - 478)
1) Apply Thermal Grease
Clean off particles and residue and then spread
the included thermal grease thinly and evenly over
the CPU that touches the FHS surface.
2) Install Clip Supports for Socket 478
Install the clip supports for socket 478 on both sides of
the retention guide as shown on the right.
3) Insert Bolts
Insert the two bolts into the inner holes of the clip.
4) Place FHS
Set the FHS at the center of the CPU. Screw the
bolts in slightly, and then tighten them in an alternating
fashion until the clip supports are completely pressed
against the clip.
5) Supply Power (Connect FAN MATE 2)
◆
Please refer to FAN MATE 2 Installation and Usage on page 7.
The specifications of any product may change without prior notice to improve performance.
※
All manuals and user guides at all-guides.com
CPU (IHS)
Thermal Grease
Clip Support for Socket 478
Retention Guide
Clip
FHS
Cilp Support for
Socket 478
①
Bolt
Inner Hole
4
Advertisement
