Table of Contents
Advertisement
1.3.2 Input Signals:
Video Input Signals Range (Analog RGB Signal)
No.
Symbol
1
Fh
2
Fv
3
Fclk
4
Vih
5
Vil
6
Video
1.3.2.1 Video Signal Amplitudes:
The video inputs consist of Red, Green and Blue signals each has its own coaxial cable terminated at
the monitor. These video signals are analog levels, where 0V corresponds to black, and 700mV is the
maximum signal amplitude for the respective color. The video signal is terminated with 75 ohms.
1.3.2.2 Video Signal T ermination Impedance:
The analog video signal termination shall be 75 ohm.
1.3.2.3 Synchronization (Sync) Signals:
The Horizontal Sync (HS) TTL signal is used to initiate the display of a horizontal line. HS may be
either active high or active low according to the timing. The Vertical Sync (VS) TTL signal is used to
initiate the display of a new frame. VS may be either active high or active low according to the timing.
1.3.2.4 Sync Signal Levels:
Level: L = 0V ~ 0.8V
1.3.2.5 Abnormal Signal Immunity:
The monitor shall not be damaged by improper sync timing, pulse duration, absence of sync,
abnormal input signal amplitude, or any other anomalous behavior of a graphics card.
1.3.3 User Controls and Indicators:
1.3.3.1 Power On/Off Switch:
The monitor shall have a power control switch visible and accessible on the front of monitor.
1.3.3.2 Power Indicator LED:
The monitor will be switched to "power saving" mode by the control signal from the display controller,
as indicated by the amber-colored power
All manuals and user guides at all-guides.com
Item
Horizontal Frequency
Vertical Frequency
Pixel Clock Frequency
High Level Input
Low Level Input
RGB Analog Video Level
H = 2.4V ~ 5V
LED.
M in
Max
Unit
30
83
kHz
55
75
Hz
148.5
MHz
2.4
5
V
0
0.8
V
0
0.7
V
8
Advertisement
Table of Contents
