Refilling Solvent - BÖWE M12 Installation Instructions Manual

8 Important Information
To fill without emissions, proceed as follows:
- Remove the screw cap on the pump line.
- Connect a hose between the barrel and pump suction side.
- Open the ball valve.
- Start program P51
- The tanks fill up, with one overflowing into the other.
- Watch the level of the liquid in the tanks and stop
program P51 when the tanks are full or when enough solvent has been filled in.
- Close the ball valve.
- Remove the connecting lines to the barrel.
- Screw the cap back on to the pump line.
With an additional 3rd tank:
- first fill up tank 1 and tank 2 (using program P51)
- fill tank 3 with P67
- fill tank 2 once more with P51
If may be necessary to refill with solvent after the filter is filled each time you replace a filter.

8.1.3 Refilling Solvent

Follow the procedure given in Point 8.1.2 for routine refilling of solvent.
Attention: Even empty containers can still hold solvent residues.
48 48
Therefore tightly seal the container (barrel) again and
store or dispose of in accordance with regulations!
8
M12-M15-M18