Safety Regulations; Safe Installation And Commissioning; Authorized Use - BÖWE M12 Installation Instructions Manual

2 Safety Regulations

Each person who is charged with the installation, commissioning, operation, maintenance or repair
of the drycleaning machine must first have read and understood the operating and installation
instructions. In particular, we refer to the observation of the relevant laws and regulations for the
countries in question.
The cleaning machine has been built according to the latest state of the technology. Only persons
who are familiar with the machine and informed of the possible risks are authorized to set up,
install, commission, operate, maintain and repair this machine. The relevant accident prevention
regulations and other regulations involving safety and medical care for workers must be strictly
adhered to.
Safety Symbols
This safety symbol identifies particular information regarding occupational
safety. It points out hazards and serves to protect personnel from physical
injury. You must observe all applicable laws and regulations; the information
on occupational safety only emphasizes particularly dangerous areas. Failure
to observe this information can result in serious consequences for the health,
up to and including life-threatening injuries.
This symbol provides important information on the correct use of the machine.
Failure to observe this information can lead to disturbances in the machine or
surrounding area.
You are not permitted to bypass or turn off safety devices or to make them otherwise inoperative.
You must observe all applicable industrial safety regulations during installation and repair work. You
must dispose of distillation residues and process water in accordance with regulations.
2.1

Safe Installation and Commissioning

You must install the drycleaning machine according to the enclosed installation instructions.
The room must be sufficiently ventilated.
You are not permitted to operate the machine in potentially explosive areas or in areas in which
systems with open flames have been installed. All electrical systems within a radius of 2 m
(approximately 6.5 feet) must comply with the IP 54 degree of protection.
The BÖWE Organization Customer Service department is responsible for carrying out
the first startup.
2.2

Authorized Use

This drycleaning machine is designed exclusively for operation with solvents with flash points higher
than the temperature information on the machine nameplate. (See "Necessary Operating Materials
and Chemical Additives"). Handle these solvents directly only when absolutely necessary and wear
protective gloves and goggles.
2 2
2
2.1
2.2
M12-M15-M18