Ms-Isdn; Multi Radio Control; Selecting Radios - Motorola MTM800 FuG Feature User Manual

68015000585-MF
Chapter 5: Features
If an accessory is connected through the junction box, the active microphone depends on the
hook state of the accessory:
• If the accessory is on the hook, the visor microphone is active.
• If the accessory is off the hook, the microphone of the accessory connected to the telco
connector is active.
2 To end the call, press the End key.
NOTICE: If you hang a fist microphone or telephone style handset into the clip or holder,
the call ends or the audio switches to a connected speaker. This call behavior depends
on the configuration of your service provider.
5.10

MS-ISDN

This feature adds to the radio ISDN number. You can choose between MS-ISDN and ISSI to address
the call, send the message or pre-defined templates. It works for both simplex and duplex calls, based
on the assigned ISDN number.
5.11

Multi Radio Control

NOTICE: This feature is a selling feature.
This feature allows the user to control two radios from a Control Head. The user can monitor one task
force and communicate with another task force simultaneously.
Radio 1 is the primary radio and Radio 2 is the secondary radio. Radio 1 and Radio 2 are connected
to each other, with Radio 1 directly connected to the control head.
5.11.1

Selecting Radios

The control head only controls one radio at a time.
When and where to use: Press the One-Touch Button to select the next available radio or perform the
following steps to select a radio via the menu.
Procedure:
1 From the home screen, press the Menu key.
2 Select Radio Selection.
3 Select one of the following options:
• Radio 1
• Radio 2
The Radio Selection Tone sounds when a radio is selected from the one-touch button or the Radio
Selection menu.
NOTICE: Check with your service provider to enable the Radio Selection Tone feature.
132