Assa Abloy Rockwood OH200 Series Installation Instructions

INSTALLATION INSTRUCTIONS
1. Select proper dimensions from chart on opposite
side of page.
NOTE: Add 5/8" to "A" dimension for dead stop.
2. Locate "B" dimension on frame and mortise 3/16"
deep for jamb bracket as shown.
3. Locate "A" and "F" dimensions on centerline of door
and mortise 13/16" wide x 7/8" deep for channel.
1/16" head clearance shown. Coordinate the arm
and rail cutout dimensions if head clearance varies.
4. Locate "C" and "E" dimensions on top of door and
mortise 1/4" deep as shown for arm clearance.
5. Install door stop or holder with screws provided.
NOTES:
• All hollow metal frames are to be provided with
3/16" min. thickness x 12" min. length
reinforcement plates.
• All hollow metal doors are to be properly reinforced
as shown.
• If dead stop is required add 5/8" to "A" dimension
as noted on opposite side of page.
• A, B and C dimensions are measured from
centerline of pivot, not edge of door.
• Reversible, non-handed.
• All dimensions are given in inches.
CAUTION: Note location
of swing clear hinge
centerline to determine
"A" and "B" dimensions.

FASTENERS:

Jamb: #12-24 x 1/2" FH MS or #12 x 1-1/2" FH WS.
Door: #12-24 x 1-1/2" FH MS or #12 x 1-1/2" FH WS.
Not To Scale
Template No.
T-OH200
Rev. 04/24/12
300 Main Street • Rockwood, PA 15557 • P: 800-458-2424 • F: 800-922-9212 • Website: www.rockwoodmfg.com
OH200 Series Concealed Door Stops and Holders
NOTE: Rockwood reserves the right to make product changes and is not
responsible for obsolete template errors. To ensure your template is current,
please visit our website at www.rockwoodmfg.com or call us at 800-458-2424.
©04.12 RMC
Rev. A