Troubleshooting; Cleaning The Appliance; Cleaning The Filters; Replacing The Filters - Black & Decker ORB4810-CA Series Instruction Manual

• Hold the appliance so that the dust collector
Emptying the appliance (Figure F)
cover (6) is facing upwards.
• Press the cover release button (7) the dust
collector cover (6) will open.
• While holding the appliance over a bin or
sink, lift out the filter (12) and empty the
contents of the appliance.
• Replace the filter.
• Close the dust collector cover (6).
Note: The filters are re-usable and should be
cleaned regularly.
WARNING:
appliance without the filters. Optimum dust collection will only be achieved with clean
filters.
• Regularly clean the ventilation slots in your appliance using a soft brush or dry cloth.

Cleaning the appliance

• Regularly clean the outside of your appliance using a damp cloth. Do not use any
abrasive or solvent-based cleaner.
• The inside of the dust bowl can be cleaned using a soft brush or dry cloth.
• The filters can cleaned using a soft brush or dry cloth.

Cleaning the filters

• The filters can be washed in warm soapy water.
• Make sure that the filters are dry before re-fitting.

Replacing the filters

The filters should be replaced every 6 to 9 months and whenever worn or damaged.
Replacement filters are available from your Black & Decker dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.
The filter can be washed thoroughly; however, use only mild soap and a damp cloth to
Maintenance
clean the main part of the vacuum.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
If the product does not work, check the following:

Troubleshooting

• The charge indicator light is on when unit is connected to charger.
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached.
• The charger is plugged into a working electrical outlet.
• The switch is in the "OFF" position when charging.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
All manuals and user guides at all-guides.com
Projectile/Respiratory Hazard: Never use the
6
F