Table of Contents
Advertisement
OVEN ASSEMBLY TO STAND
1. Place the assembled stand in the location where the
oven is going to be used.
2. Remove the side control compartment cover and
open the front control panel of a single oven (or lower
section).
3. With a tool, punch out the knock-outs in the oven bot-
tom near each corner.
4. Set the on the stand. Center it to the frame.
NOTE: There should be approximately 1/2" of stand
visible on all sides of the unit.
5. Align the front and rear bolt holes of the oven with the
bolt holes in the stand.
6. Insert a bolt and washer, from the top down through
each of the two holes.
7. Place a nut and washer on each of the bolts and tight-
en securely.
8. Replace the oven's side control compartment, and
close the front control panel.
NOTE: For single section ovens only. For double
stacked ovens step 8 will be completed once
the ovens are stacked.
Oven Leveling
1. Place a level on top of the oven. Loosen the set
screws on the side of each caster. Turn the adjust-
ment collar clockwise to raise and counter clockwise
to lower the oven.
2. When the oven is level, tighten the casters by turning
the two set screws on the side of each caster assem-
bly.
Figure 2
5
Installation
Oven Assembly
Advertisement
Table of Contents
