Table of Contents
Advertisement
Embedded system module LAN connection
Changes to the Embedded System Module (ESM) LAN connection are only
detected when you power up the ESM. Therefore, whenever you change the ESM
LAN connection, do the following:
14
1 Power down the M9537A using the Shut down selection on the Windows
Start menu.
2 After shut down is complete, power down the chassis using the chassis
power button.
3 Make the desired change to the LAN connection.
4 Use the chassis power button to power up the chassis and M9537A
controller.
5 After Windows starts, verify that your LAN interface is operating correctly.
Step 3: Install the M9537A Embedded Controller
Keysight M9537A AXIe Embedded Controller Startup Guide
Advertisement
Table of Contents
