7
Checking the Fluid Levels
No Parts Required
Procedure
1.
Check the level of the rear axle lubricant before
the engine is first started, refer to
Oil Level of the Rear Axle (page
2.
Check the level of the hydraulic fluid before
the engine is first started, refer to
Level of the Hydraulic Fluid (page
3.
Check the level of the engine oil before and after
the engine is first started, refer to
Engine-Oil Level (page
8
Using the Gauge Bar
Parts needed for this procedure:
1
Gauge bar
Procedure
Use the gauge bar to adjust the cutting unit. Refer to
the cutting unit Operator's Manual for the adjustment
procedures
(Figure
24).
Checking the
63).
Checking the
69).
Checking the
56).
1. Gauge bar
2. Height-adjusting screw
3. Nut
9
Applying the CE Decals
Parts needed for this procedure:
1
Warning decal
1
CE decal
1
Production year decal
Procedure
On machines requiring CE compliance, apply the
production year decal (Part No. 133-5615) near the
serial plate, the CE decal (Part No. 93-7252) near
the hood lock, and the CE warning decal (Part No.
138-1186) over the standard warning decal (Part No.
120-1683).
19
Figure 24
4. Holes used for setting the
groomer height of groom
(HOG)
5. Hole not used
g004552