Advertisement
調整
1. 上送齒行程大小之調整 ( 圖 2)
行程大小由 1.5~5.5mm 無階段性調整
O
(1. ) 用左手壓下按鈕
A
，再以右手轉動手輪直
到左手手指感覺按鈕崁入到機器內部卡槽。
(2. ) 持續轉動手輪選擇所需之行程大小對準
，然後放開按鈕。
(3. ) 配合下送齒縫距，依手輪上紅色刻度
整上送齒所需行程即可。
ADJUSTMENT
1. Adjust the top feed stroke (Fig. 2)
Adjust the stroke from 1.5 to 5.5mm without
periodic adjustment
(1. ) Press button
hand wheel with right hand until the left hand
finger feel the button enters the machine slot.
O
(2. ) Keep turning the hand wheel until
B
at the required stroke level , and release the
button.
O
(3. ) Adjust the required top feed stroke according to
調
C
red mark
with bottom feed teeth distance.
B
A
Introduction
O
with left hand ， and turn the
A
O
on the hand wheel in coordination
C
C
圖 2 / Fig. 2
O
pointed
B
P3
Advertisement
