FAQ
If the lock is not operating normally, refer to following points. Should the problem
continue after following these instructions, contact your nearest service centre.
• Security code can not be set.
- Be sure to press each digit within 5 seconds the display lamp should be on
during the security code setting. Try resetting the code as indicated page 10.
• Automatic locking function does not operate.
- Make sure that Automatic / Manual transition switch is set to the Automatic
locking position.
- Open the door and Press the open sensor to activate the dead bolt to verify the
operation with the door open.
- Ensure the batteries are fully charged.
• The door does not lock when closed.
- Check the bolt function and striker alignment.
• The lock will not power up.
- Ensure all batteries are correctly inserted and fully charged.
• The lock will not open when entering the security code and
- Ensure you enter the security code when the keypad lamp is on.
button.
21