Control Operation; First Use; Ice - U-Line 1000 Series Quick Start Manual

QUICK START GUIDE
QUICK START GUIDE
USER GUIDE

Control Operation

Control Operation
CONTROL FUNCTION GUIDE
FUNCTION
CONTROL FUNCTION GUIDE
ON/OFF
FUNCTION
Adjust ice thickness
ON/OFF
Enable Sabbath Mode Adjust ice thickness
View temperature in unit
Disable Sabbath Mode
Toggle between F/C
Silent Mode (ice
production suspended for
Sabbath Mode
3 hours)
Silent Mode (ice
Clean Mode
production suspended for
3 hours)
Showroom Mode
Clean Mode
This unit is Star-K certified. See www.star-k.org for more details.

First Use

All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends discarding the ice produced
during the first two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
When plugged in, the unit will begin operating under the
factory default settings. If the unit was turned off during
installation, simply press
switch on. To turn the unit off, press
5 seconds and release.
Control Operation
Up Down
COMMAND
Press and release
COMMAND
See "Ice" section
Press and release
Press and hold for 5 seconds and
See "Ice" section
release
Press and together and release
Press and release
Hold for five seconds
and
Hold and
See "Sabbath Mode" section
See "Cleaning" section
Hold and
Hold and for 5 seconds
Hold for five seconds
and the unit will immediately
and hold for
Light Power Clean LED
NOTES
Unit will immediately turn On or OFF
DISPLAY/OPTIONS
Unit will immediately turn ON or OFF.
The o F / o C symbol will flash briefly after 5 seconds.
Interior light and display will go dark and remain so
until user resets mode - unit continues to operate
The display will flash and then toggle from set point
Display and interior light return to normal operation to temperature in unit.
The display will beep and display unit temperature.
Display will countdown the hours: 3H, 2H,
Display will show "OF
The º F / º C symbol will flash. Display will be lit and
interior light will function. Unit will not cool. Repeat
command to return to normal operation

Ice

ICE CUBE THICKNESS ADJUSTMENT
NOTICE
Ice thickness adjustment should only be made
one increment at a time. Allow ice maker
production to stabilize for 24 hours before
rechecking ice thickness.
Ice is produced in layers resulting in a clear cube. Ice in
bin may develop surface frost which disappears when cube
is placed in liquid.
Ice cubes in any given batch will vary, so it is necessary
to choose cubes from the sample area for comparison
when making adjustments.
11
10
u-line.com
u-line.com
u-line.com
1H
".
F