U-Line 1000 Series Quick Start Manual page 15

QUICK START GUIDE
QUICK START GUIDE
The ice cube thickness is factory set for best overall
performance. The factory setting is designed to maintain
an ice bridge of approximately 1/16" to 1/8" (1.6 mm to
3.2 mm) under normal conditions, resulting in a dimple of
approximately 1/4" to 1/2" (6.4 mm to 12.7 mm) in
depth. A fuller cube with less of a dimple results in a
thicker ice bridge. As the ice bridge becomes thicker, the
tendency for the cubes to stay together as a slab
increases. A bridge thicker than 1/8" (3.2 mm) may cause
cubes to overfill the ice bucket.
32 ice cubes are formed on a 4 x 8 slab during each cycle.
Each cycle takes approximately 15-20 minutes at the
default cube thickness (0).
7/8"
(22 mm)
7/8"
(22 mm)
DIMPLES
ICE BRIDGE
Your clear ice machine is pre-set to produce ice between
the optimal dimensions illustrated below:
1/4" TO 1/2"
(6.4 mm to 12.7 mm)
DIMPLE
Factory Default Setting - 0
THINNER BRIDGE
DEEPER DIMPLE
< 0
SETTING
Ice thickness adjustments are made using the control
panel as follows:
1. To enter the thickness adjustment mode:
• Press and hold
• The display will switch to "0" to confirm the
thickness adjustment mode has been selected.
The factory setting is "0". Use
thicken the ice bridge, or
the ice bridge.
Ice cubes in any given batch will vary, so it is necessary
to choose cubes from the sample area for comparison
when making adjustments.
Copyright © 2014/2017 U-Line Corporation. All Rights Reserved.
12
11
u-line.com
Cube Details
1/16" TO 1/8"
(1.6 mm to 3.2 mm)
ICE BRIDGE
THICKER BRIDGE
SHALLOWER DIMPLE
> 0
SETTING
for 5 seconds.
to raise the setting and
to lower the setting to thin
Publication Number 30629 11/2019 Rev.A
u-line.com