Control Panel - Russell Hobbs RH12DSBCAN Instruction And Warranty Book

Control Panel

Figure 2
Power Select ON/OFF Button. Press this Button to turn the
unit ON to start the brewing process. You can also turn the
unit OFF by pressing this Button when the brewing cycle is
complete. The Red ON Light, above the ON/OFF Button, will
illuminate when the Coffeemaker is ON. The Green AUTO
Light, above the Drip Button, will illuminate when the
Coffeemaker has been programmed.
HR Button. Use this Button to display the correct hour when
setting the time.
MIN Button. Use this Button to display the correct minute
when setting the time.
PROGRAM Button. Use this Button to program your
Coffeemaker to start brewing at a specified time.
Brew Strength Button. Use this Button to select a stronger
strength of brew. To ensure optimum flavor, the Brewing
Strength Selector regulates the brewing process based upon
the amount of coffee being prepared. When preparing 4 cups
or less, press this Button. A cup will appear in the Display. This
will slow down the flow of water into the Filter Basket to
provide a rich coffee flavor by promoting a better saturation
of grounds for smaller quantities. When preparing 5 or more
cups, reset the selector. The cup will disappear from the
window. This will prepare a full pot of coffee at the normal
rate, allowing ample time for the grounds to be saturated,
without imparting a bitter taste.
Drip Button. This Button is used to initiate the programmed
pre-set brew time. You may also cancel the pre-set brew time
by pressing this Button as well.
5