Advertisement
3D
ONE SINGLE-CIRCUIT
WHITE SIDE
T~TRAK SECTION
GRAY SIDE
Look inside the conductive connector and make sure
9
that the white insulator is facing up toward the ceiling.
10
Push the conductive connector onto the end of one
Single-Circuit T~trak section and tighten the bottom
#4-40 screw with a Phillips screwdriver for proper
power connection.
SAVE THESE INSTRUCTIONS!
CONDUCTIVE
CONNECTOR
10
BOTTOM #4-40 SCREW
3E
WHITE SIDE
1
12
GRAY SIDE
11
Push the other Single-Circuit T~trak section into the
other end of the conductive connector and tighten the
bottom #4-40 screw with a Phillips screwdriver for
proper power connection.
12
Cut the excess aircraft cable for a nice and neat look
with a sharp cutter after leveling all standoffs to the
desired height.
T ~ t r a k
7400 Linder Ave.
Skokie, IL 60077
847.410.4400
www.ttraklighting.com
4
CONDUCTIVE
CONNECTOR
THE OTHER SINGLE-CIRCUIT
T~TRAK SECTION
11
BOTTOM #4-40 SCREW
TM
a brand of
1
Advertisement
