Advertisement
SPECIAL INSTALLATION:
Converting the Standoff
NOTE: In the event that the standoff cannot be
located directly above the conductive connector,
the following steps will allow for the standoff
to be installed in close proximity to the
conductive connector while still providing
support and a connection between Single-
Circuit T~trak sections.
3A
2
HOUSING NIPPLE
3
4
HOUSING
Follow the "Install the Standoff " steps on pages 1 & 2.
1
Unscrew the housing nipple from the housing by
2
turning the housing nipple counterclockwise.
3
Remove the housing and the conductive connector from
the housing nipple.
4
Remove the conductive connector from the housing.
3B
PLASTIC INSERT
Place one of the provided plastic inserts (with open
5
section facing up) all the way into bottom of the
housing.
Place the Single-Circuit T~trak into the housing. Make
6
sure that the Single-Circuit T~trak white insulator is
facing up toward the ceiling.
7
Push the other plastic insert (with open section facing
down) onto the Single-Circuit T~trak.
3C
CONDUCTIVE
CONNECTOR
8
Tighten the housing nipple to the housing by screwing
the housing nipple clockwise. Make sure not to cross
thread.
3
PLASTIC INSERT
5
HOUSING
SINGLE-CIRCUIT T~TRAK
1
8
HOUSING
NOTE:
In case of cross threading, unscrew the
housing from the housing nipple and repeat step 8.
WHITE SIDE
7
6
GRAY SIDE
HOUSING NIPPLE
Advertisement
