Ultra electronics HyperSpike TCPA-Omni Installation And Mounting Manual page 4

2.0 TCPA-OMNI MOUNTING
WARNING: WHEN MOUNTING OUTSIDE MAKE SURE THAT THE SUPPORT SYSTEM
USED HAS THE PROPER WIND LOAD RATING AND COMPLIES WITH LOCAL
STANDARDS AND CODES.
AVERTISSEMENT: LORS DU MONTAGE DEHORS ASSURER QUE LE SYSTÈME DE
SUPPORT UTILISE A LA BONNE COTE CHARGE AU VENT ET CONFORME AUX NORMES
ET CODES LOCAUX.
WARNING: THIS IS A FIRE ALARM DEVICE – DO NOT PAINT (NE PAS PEINTURER –
DISPOSITIF D'ALARME)
The TCPA-Omni comes standard with a 3/4" NPSM threaded coupler to hang the unit. (Figure 1) It
is also provided with 10ft electrical leads that exit the unit through the mounting coupler.
The TCPA-Omni is intended to be mounted /suspended from the coupler on the top plate, i.e.,
hanging from a ceiling. Although the unit can be hung from a ridged mount, hanging from a high
bay hook or a swivel hanger will allow proper leveling
1) To mount the TCPA-Omni take the black and red wires coming out of the conduit and feed
them through the rigid conduit that is being used to mount the unit (customer supplied).
90185A-MAN-OMNI
Figure 1: Location of the 3/4" NPSM threaded conduit
Copyright © Ultra Electronics – USSI , Columbia City, IN 46725 USA
®
HyperSpike TCPA - Omni Installation and Mounting Manual
REV B 2015/12/15