Clutch Lever; Shift Pedal - Yamaha R15 YZF155 2018 Owner's Manual

Instrument and control functions
Start switch " "
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
Hazard lights switch " / "
The hazard lights (simultaneous flash-
ing of all turn signal lights) are used in
case of an emergency, such as to warn
4
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
Set this switch to " " to turn on the
hazard lights. To turn off the hazard
lights, set the switch to " ".
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12713

Clutch lever

1
EAUU1021
1. Clutch lever
The clutch lever is located on the left
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
ECA10062
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the start-
ing circuit cut-off system. (See page
4-18.)
4-12
EAU31642

Shift pedal

1
1. Shift pedal
The shift pedal is located on the left
side of the motorcycle and is used in
combination with the clutch lever when
shifting the gears of the 6-speed con-
stant-mesh transmission equipped on
this motorcycle.
EAU12872