Replacing A Turn Signal Light Bulb; Supporting The Motorcycle; Front Wheel - Yamaha R15 YZF155 2018 Owner's Manual

Periodic maintenance and adjustment
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1
1. Screw
7
2. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
[ECA11192]
EAU24205

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motorcy-
cle is in a stable and level position be-
fore starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing a
jack under the frame in front of the
rear wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
7-32
EAU24351

Front wheel

To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the front wheel axle nut
and the brake caliper bolts.
1. Axle nut
2. Lift the front wheel off the ground
according to the procedure in the
previous section "Supporting the
motorcycle".
EAU24361
EAUN0582
EWA10822
1