Advertisement
Available languages
Available languages
Keep ventilation openings, in
the appliance enclosure or in
the built-in structure, clear of
obstruction .
Automatic ice-makers and/or
water dispensers must be
connected to a water supply
that delivers potable water
only, with main water pressure
between 0,17 and 0,81 MPa (1,7
and 8,1 bar) .
To guarantee adequate ventila-
tion, leave a space on both
sides and above the appliance .
The distance between the rear
of the appliance and the wall
behind the appliance should
be at least 50mm .
A reduction of this space will
increase the Energy consump-
tion of product .
INTENDED USE
OF THE PRODUCT
This appliance is designed
solely for use as domestic
usage . To aim the appliance as
professional use is forbidden .
The manufacturer declines
allresponsibility for innapropi-
ate use or incorrect setting of
the controls .
The appliance is not intended
to be operated by means of an
external timer or separate
remote control system .
Do not use the appliance
outdoors .
This appliance is intended to
be used in household and
similar
applications such as:
– staff kitchen areas in shops,
offices and other working
environments;
– farm houses and by clients in
hotels, motels and other
residential type environments;
– bed and breakfast type
environments;
– catering and similar non-
retail applications .
The bulb used inside the appli-
ance is specifically designed for
domestic appliances and is not
suitable for general room
lighting within the home (EC
Regulation 244/2009) .
INSTALLATION
Only activate the appliance
when the installation proce-
dure has been completed .
Installation and repairs must
be carried out by a qualified
technician, in compliance with
the manufacturer's instructions
and local safety regulations . Do
not repair or replace any part
of the appliance unless specifi-
cally stated in the user manual .
Use protective gloves to per-
form all unpacking and instal-
lation operations .
The appliance must be discon-
nected from the power supply
before carrying out any instal-
lation operation .
After unpacking the appliance,
make sure that it has not been
damaged during transport . In
the event of problems, contact
the dealer or your nearest
After-sales Service .
During installation, make sure
the appliance does not dam-
age the power cable .
The appliance must be han-
dled and installed by two or
more persons .
When installing the appliance
make sure that the four feet are
stable and resting on the floor,
adjusting them as required,
and check that the appliance is
perfectly level using a spirit
level .
Wait at least two hours before
switching the appliance on, to
ensure that the refrigerant
circuit is fully efficient .
Make sure the appliance is not
near a heat source .
ELECTRICAL WARNINGS
Make sure the voltage speci-
fied on the rating plate corre-
sponds to that of your home .
The power supply ranges are
indicated on the rating plate .
Regulation require that the
appliance is earthed .
For installation to comply with
current safety regulations, an
omnipolar switch with mini-
mum contact gap of 3mm is
required .
If the power cable is damaged
it must be replaced with an
identical one . The power cable
must only be replaced by a
qualified technician in compli-
ance with the manufacturer
instruction and current safety
regulations . Contact an author-
ized service center .
The electrical components
must not be accessible to the
user after installation .
EN
11
Advertisement
