Download Program - ADEEPT RaspClaws User Manual

Smart robot kit for raspberry pi
Hide thumbs Also See for RaspClaws:
Table of Contents

Advertisement

The password for login is raspberry by default.
* When you typing in the password, nothing will appear on the screen but it does not mean
no input. Type in the password carefully and press Enter after it's done.
Log in successfully.

2.2 Download Program

Setting up in a Raspberry Pi may take you a lot of time, and there are too many libraries
needed, so we write a python program to do the most of works for you.
Download the program of the raspclaws.
Input the code below to download:
git clone https://github.com/adeept/adeept_raspclaws.git
Then setup:
sudo python3 adeept_raspclaws/setup.py
It may take some time to finish.It may take 2-3 hours to install, and we need to wait
patiently.Also do not turn off or disconnect the Raspberry Pi. If the installation fails in
this step, please contact us at
When the Raspberry Pi software is installed, the Raspberry Pi will automatically restart.
And the program runs automatically after booting.At this time PuTTy will automatically
disconnect.
The Raspberry Pi program has been installed when it comes to this step.Next we need
to assemble the robot, please shut down the Raspberry Pi and remove the power
supply.
support@adeept.com
in time.
www.adeept.com
11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RaspClaws and is the answer not in the manual?

Table of Contents