Table of Contents
Advertisement
Available languages
Available languages
If you attempt to set more than 10 waypoints, you will receive
the message MEMORY FULL.
NOTE: You can also store waypoints in Navigate Mode.
TO VIEW OR EDIT WAYPOINTS
s
1. Press
(DISPLAY) to recall a stored waypoint.
L
2. Choose one of the following options to view or edit a waypoint:
To view a waypoint, press
the waypoint you wish to view.
You can also continue to press
navigate back to the current location.
To change the label of a waypoint, press SET/FORMAT
until you locate the label you wish to use.
40
View stored
waypoints
C
h
a
n
g
e
l
a
b
e
l
for
C
h
a
n
g
e
l
a
b
e
l
stored waypoints
E
r
a
s
e
stored
E
r
a
s
e
waypoints
s
(DISPLAY) until you locate
L
s
(DISPLAY) until you
L
To erase a waypoint, press and hold STOP/RESET .
If you erase a waypoint, it will not re-order the other
waypoints. For instance, if you have labeled your waypoints
WAYPNT 1, 2, and 3 and you erase WAYPNT 2 you will
then have waypoints labeled WAYPNT 1 and 3.
TO OPERATE THE TRACK BACK FEATURE
Activate
Track Back
You can activate the Track Back feature when you are ready to
navigate from a current position to one of your stored waypoints.
When activated, the Track Back feature takes over Waypoints
Mode. You cannot perform any other functions until you
deactivate Track Back.
s
1. Press
(DISPLAY) to select the desired waypoint.
L
2. Press and hold START/SPLIT. You will see the message
HOLD TO BEGIN TRACK.
Recall a stored
waypoint
Deactivate Track
Back
41
Advertisement
Chapters
Table of Contents
