Figure 53: Connecting Diagrams; Re-Crimp Procedure - Motorola MTM800 FuG Installation Manual

84 | Connectors and PIN Assignment

Figure 53: Connecting Diagrams

SPEAKER + 9
SPEAKER - 10
EXT_PTT 17
GND 8
EMERGENCY 23
GND 8
SPEAKER + 9
SPEAKER - 10
IGNITION 25
MIC1/EXT_MIC 13
GND_MIC 16
Caution: HKN9327_ Ignition Sense Cable: If the ignition line is not used, it needs to be grounded.
Interference can cause radio to hang.

Re-crimp Procedure

To use accessories from MTM800 such as RLN4858_ and GKN6272_ with the rear connector of the radio, follow the
re-crimp procedure using the crimp pins provided with PMLN5072_ connector kit. These accessories do not require
to be re-crimped when used with the Data Junction Box GMLN5089_.
Process:
1 Cut and remove nickel plated pins from wire.
2 Strip the insulation from the end of the wires (2 mm to 4 mm).
3 Place the new gold plated crimp pin (from the PMLN5072_ kit) on the gauge slot on the crimp tool.
4 Insert wire into the wire slot of the crimp pin.
5 Apply pressure to the crimp tool handle, until wire is crimped by the pin.
Send Feedback | | 68015000584-J
RSN4002 Speaker 13 W
RSN4004 Speaker 5 W
RLN4857 Pushbutton w/Remote PTT
RLN4858 Gooseneck PTT
12k
RLN4836 Tri-state Emergency
Footswitch and Cable
PMKN4119 Speaker Extension Cable
9
10
HKN9327 Ignition Sense Cable w/ fuse
4 A
+12 V/
+24 V
Car Ignition
Switch
PMMN4087 Visor Microphone w/ cable
GMMN4065
PMLN5072 Accessory connector kit containing:
1516174H01 Accessory Connector 26-pin
3915560H01 Crimp Contact 20-24 AWG (quantity 27)
4210217A02 Nylon Tie Rap
6671929L01 Service Tool
The recommended crimp tool (not part of PMLN5072):
SamTec P/N: CAT-HT-179-2024-11910910
GMLN5091 External Alarm Relay Kit containing:
GKN6272 External Alarm Relay and Cable
PMLN5072 Accessory Connector Kit
+12 V
86
87
85 30
EXT_ALARM 26
+12 V
SWB+ 7
86
87
30
85
EXT_ALARM 26
+12 V
+12 V