Before Use; Lubrication; Refilling Oil; Connecting To A Compressed-Air Source - Parkside PDBS 1800 A1 Original Instructions Manual

Before use

NOTE
► The compressed-air tool may only be operat-
ed using cleaned, oil-atomised compressed
air and the maximum operating pressure of
6 .8 bar must not be exceeded on the tool .
The compressor must be fitted with a pressure
reducer to regulate the working pressure .

Lubrication

WARNING!
► Inform yourself about the health hazards of
the oil used in the safety data sheet of the
respective manufacturer .
NOTE
► Regular lubrication is particularly important to
avoid friction and corrosion damage .
We recommend using a suitable special oil
for compressed-air tools (e .g . Liqui Moly
compressor oil) .
–
Lubrication with mist oiler
A mist oiler (not supplied) continuously
and optimally lubricates the grinder as a
preparation stage after the pressure re-
ducer . A mist oiler gives off fine drops of
oil into the air flow and thus guarantees a
regular lubrication .
–
Manual lubrication
If you do not have a mist oiler, lubricate
the tool before every use or longer work
sessions . Add 3–4 drops of pneumatic
oil into the connector nipple
PDBS 1800 A1

Refilling oil

To ensure that the tool remains operational for
a long time, it must have a sufficient supply of
pneumatic oil .
You have the following options:
♦ Attach a maintenance unit with an oiler to the
compressor .
♦ Install a fitted oiler into the compressed-air line
or the compressor .
♦ Add 3–5 drops of pneumatic oil into the
connector nipple
operation .
Connecting to a compressed-air
source
NOTE
► Before connecting the compressed-air source
–
–
► Use only connection hoses with an internal
diameter of at least 9 mm .
► Use only filtered, lubricated and regulated
compressed air .
♦ Attach the tool to a compressor by connecting
the connector nipple
the compressed-air source .
CAUTION!
► Ensure that the compressed-air hose is firmly
.
attached . A loose hose can thrash about
uncontrollably causing grave danger . Likewise,
ensure the firm seat of the two screw connec-
tions between the coupling piece and the tool .
♦ The compressed-air source must be equipped
with a pressure reducer so that you can regulate
the air pressure .
after every 15 minutes of
the correct working pressure (3–6 .8 bar)
must be fully reached, and
you must ensure that the trigger is in the
upper position
with the supply hose of
GB │ IE │ NI │ 11 ■