Installing The Axkid Modukid Seat On The Base - Axkid Modukid Base Instruction Manual

Installing the Axkid Modukid Seat
on the base
When installing an Axkid Modukid Seat to the base, pull the seat release handle (E) to its
12
extended position (see F6) and push the seat to the base. The seat attachment plate shall click
into the base.
Ensure that the Axkid Modukid Seat is not in contact with any adjacent vehicle seat and that
13
the support leg is firmly clamped to the floor and that the support leg installation buzzer (O) has
stopped buzzing.
Axkid has equipped the Axkid Modukid Seat with a side impact protection system, ASIP
(Axkid Side Impact Protection). To install the ASIP, locate the side impact pad connector on the
child seat nearest to the side of the vehicle (i.e. closest to the door). Ensure the two triangular
arrows on the side impact pad point in the same direction as the triangular arrow on the side
14
impact pad connector. Place the upper of the two oval openings on the underside of the side
impact pad over the side impact pad connector. Push the side impact pad against the side of
the car seat and slide the side impact pad upwards onto the side impact pad connector. You
will feel a slight click as the side impact pad locks in place. To remove: push the side impact pad
downwards and remove.
IMPORTANT:
See your Axkid Modukid Seat manual for full instructions on how to install the product and how to
buckle your child in the seat.
8