Allowed and disallowed positioning of the
baby car seat
The Axkid Modukid Base can be installed on any forward-facing passenger seat which has ISOFIX
connection points
IMPORTANT: If you wish to install your Axkid Modukid car seat in a location where an airbag is fitted,
the airbag must be disconnected at an authorized service center. Some vehicles may be equipped
with a switch which allows you to manually switch the airbag off. It is important to always check if the
vehicle' s indicator light shows that the airbag is turned off.
WARNING: Never use on a seat with an active airbag
WARNING: Never use on rearward or side facing vehicle seats
WARNING: Air bags are designed for adults and can seriously harm your child in a crash
1
Allowed and disallowed positioning of the child car seat.
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Forward-facing seat with ISOFIX connection points
Seat without ISOFIX connection points
Side facing seats
Rear facing seats
2
This base is only allowed to be mounted rear-facing.
Never install a child restraint in a passenger seat
where an active airbag is fitted.
Installation in the car
Attach and adjust the front brace (A) to its innermost position. Fold out the support leg (M).
When the support leg is unfolded the support leg installation buzzer (O) will start beeping. The
3
beeping will stop after correct installation is completed.
4
Extend the ISOFIX arms (F) to a suitable position P1-P4.
6
Yes
NO
Yes
NO
NO
NO
Need help?
Do you have a question about the Modukid Base and is the answer not in the manual?