Faema X2 Granditalia Manual page 15

English
The sub-menu of the Version entry shows the memory display version
and, if present, also the remote control:
VERSION
DISPLAY
COMPUTER
TELEC.
The "Setup" entry displays the setup settings introduced during the
Data Standard insertion phase:
Before performing this operation, switch off the machine and
position dipswitch 1 on display screen = ON, then switch on the
machine.
If the procedure described above is not performed (dip1=ON), this
message will appear on the display:
NEW SOFTWARE VERSION
When inputting the Standard Data, you are prompted to input data
regarding model and type of machine:
- MODEL: 1, 2, gruops;
- TYPE: coffee, coffee+ TS, cappuccino;
- MENÙ: different types of drinks
The "dip setting" entry displays the dipswitch settings.
DIP SETTINGS
1 2 3
+
u
025.00.A0
u
Entering Standard Data
******************
LOAD
STANDARD DATA
******************
ON
OFF
4 5 6 7 8
Version
When the PRG (29) key is pressed when the cursor is on each of the
two lines, besides showing the version, it also displays the data for
the revision and memory date.
VERSION
DISPLAY
REV.
DATE
Setup
Using the "+" key (30) and the "-" key (31), select the parameters,
then press the "PRG" key (29) to confirm the details.
After this operation, switch off the machine and reset the
dipswitch 1 display screen to OFF.
Then:
- Switch on the machine again
- Reset date and time, and reset the desired language, if needed.
- Reset maintenance parameters (see "Configuration menu -
Maintenance")
- Zero the error log.
Dip settings
Under standard conditions, the dip-switches are positioned on
OFF.
- DIP 1 = OFF - ON Input of standard data
- DIP 2 = OFF
- DIP 3 = OFF - ON Simulation of engineer's card
- DIP 4 = OFF - ON Simulation of bookkeeping's card
- DIP 5 = OFF
- DIP 6 = OFF
- DIP 7 = OFF
- DIP 8 = OFF
For more details, please consult the technical manual at the "Setting
- CPU Dip-Switch" paragraph.
62
025.00.A0
00
31/01/2004
STANDARD DATA
– –
1 GR
– –
Coffee + TS
– –
Menu 1
English
+
u
u